Change Logs

Fixed issue with debug printing causing crashing when usb stick plugged in.

Increased readings timeout to work with thermocouple pods.

Fixed issue with graph scale not being saved to settings.

Fix bug when device full with data.

Added % full to admin page

Fix device rebooting when scanning for readings to send to D1.

Force device to save settings immediately after receiving token and code.

Fix graph not updating after every reading.

Disable alarms settings buttons when D1 is enabled.

Display correct channel number in alarms subpage.

Changed the way we scan for readings to send to D1 to improve OTA download speed.

If a firmware is already downloading, don’t restart firmware download process after 8 hours.

Enabled D1 alarm API handling.

Fixed audible alarm silencing with button.

Keep blinking alarm bell if alarm has been “silenced”

Display “powering down” when device is turned off with power button

Change instances of “pod” in text to “RS”

Reduce number of retries for firmware packets

Force readings to be sent after each firmware packet send attempt.

Fixed some potential causes of multiple pods with garbage data showing up.

Retry sending same readings to D1 if send fails instead of moving on to next readings

Fix potential early notification that device is full

Improved transfer speed over USB device for DicksonWare

Prevent device from sending multiple registration packets in a row

Allow for some additional replacement pod conditions

Fix serial number display in CSV data

Fixed problems regenerating graph buffer when time scale is set to 7 days or above

Allow latest data point to be shown even if only one point exists in graph buffer

If pod has been replaced, make sure the most recent pod information is sent to DicksonWare

Prevent device from overwriting incorrect settings during D1 alarm API communication.

Temporarily disabled D1 alarms API.